Table of Contents
What is a reverse light switch?
The reverse light switch is a mechanical device used to control operation of the vehicle reverse lights. The switch is designed to complete the circuit when reverse gear is selected allowing reverse light operation (manual transmission only).
How do you check reverse lights?
Testing Reverse Lights Turn the ignition switch to the “on” position (without starting it), then put the transmission in reverse with the parking brake on. It is very important to make sure the parking brake is on. Once that is set, get out of the vehicle and look at the reverse lights, they should be illuminated.
How much does a reverse light switch cost?
Backup Light Switch Replacement Cost – RepairPal Estimate. Labor costs are estimated between $44 and $55 while parts are priced at $48. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
Which fuse is for reverse lights?
The reverse light fuse (called “backup light” in the manual) is actually fused via the IG1 circuit. It’s located in the under steering wheel dash fuse box. It’s 10 amp mini blade and is the middle top location.
What would cause my reverse lights to stay on?
The most likely cause of that is a failed switch, in this case failing in the ‘on’ position. You can check this by disconnecting the wiring from the switch (which will either be on the gearbox or near the gear lever) and checking that the lights don’t come on.
Why is my reverse light always on?
Why is my reverse lights staying on?
Reverse lights stay on at all times Another symptom of a failed backup light switch are reverse lights that are on at all times. If the switch shorts internally, this may cause the lights to stay on permanently.
Why is my reverse light not working?
First check that the bulbholder and wiring terminals are clean and bright. If there is any corrosion, clean it up with wet-or-dry paper then refit the bulb and retest. If the bulb still fails to light, the fuse may have blown. You should also suspect a blown fuse if two reversing lights go together.
Are reversing lights mandatory?
By law a reversing light is classed as an optional light and not an obligatory light, therefore there is no requirment to have oner at all. However it goes on to state that if you do have an optional light fitted then it must comply with regulations which merely state, 1.
What would cause reverse lights to stop working?
On the other hand, if there is no power to the bulb terminals, there could be a faulty circuit ground, a wire break, a blown fuse (which itself would signify a circuit fault such as a short), or a bad neutral start safety switch which switch typically has the reverse light activation switch built into it.