Table of Contents
Does a piezo igniter need to be grounded?
You simply slide the 6 connectors on to the 6 burner igniter and you’re good to go. No splicing, wiring, or grounding is needed.
How does an igniter electrode work?
The spark electrode is essentially a spark plug placed directly in the path of the low-pressure gas flowing from the pilot light jet. The spark electrode produces a continuous spark at the rate of two to four sparks per second. The secondary pilot remains lit until the oven is shut off.
The Igniter Button is the rubber push button that you press to ignite the burner(s). The Igniter Button is the rubber push button that you press to ignite the burner(s).
How long does a piezo igniter last?
How long does it last? While matches and lighters must be replaced or refilled, matchfree ignition systems are built to last for life. While malfunctions do occur, the average piezo lighter lasts for a minimum of ten years, far longer than even a whole box of matches!
How do you test piezo igniter?
Connect the piezo igniter to the electrode (figure 3), holding the electrode about ¼” to ½” away from the shell of the heater with the insulated pliers depress the piezo igniter. If a spark is present every time the igniter is pressed, the piezo igniter is fine, if no spark is seen, replace the piezo igniter.
Can a piezo igniter be repaired?
Can a piezo igniter be fixed? Piezo Igniter: The piezo igniter (figure 1) is also known as the “push button” igniter. The piezo igniter generates a spark that is transferred to the ignition source. There are no serviceable parts.
Where are the igniter wires on a grill?
Slide each igniter wires back into place bringing them along the inside of the control panel and plugging them into the ports on the module. The longest wires are for the left side burners and the shortest wires are for the right side burners. The ports are not specific.
Do you need ground connection for ignition module?
A lot of modules need a clean ground connection either from an extra wire mounted to a steel support bracket, bolt or nut inside the control panel and these modules will still generate a spark but much weaker when they are not grounded. With aluminum grills an extra wire is necessary.
What should I do if my igniter is not working?
Usually if the ignition is not working, we need to get into the lower fire box of the barbeque and clean the tips of the electrodes with a little degreaser and a small file or a little sandpaper. This is the way to repair the ignition about 90 percent of the time.
What does the L terminal on an igniter do?
When the igniter is sparking, the “L” terminal sends a pulsing high voltage DC signal to whatever it is connected to. The “L” terminal could be connected to an ignition light or to a circuit board. If there is no spark at the burner, first remember that the igniter senses the resistance between the burner and the electrode.